







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Paver Driveways in Laguna Beach, CA: What the Job Actually Takes
A paver driveway in Laguna Beach usually runs $7,000 to $18,000, takes three to six working days on a typical residential drive, and is built over a compacted aggregate base that has to be engineered for slope before a single paver drops. Most of the driveways we build here sit on canyon lots where grade and drainage decide the whole job. Call (833) 954-6066 and we’ll walk your driveway, check the slope, and put a written number in front of you.
How We Build Paver Driveways Here, Stage by Stage

The sequence matters more than the pavers. Skip a step on a Laguna Beach slope and the surface will show it inside two winters.
Day 1: Site walk, measurements, and base depth call
We measure the drive, check the existing surface, and look at where water actually flows when it rains. On a hillside lot that means finding the low corner and the path runoff takes toward the street. Base depth gets set here, typically 4 to 6 inches of compacted aggregate, deeper where the subgrade is soft or the slope is steep. You decide the paver style and the edge restraint at the end of this visit.
Day 1-2: Demolition and haul-off
Old asphalt, cracked concrete, or worn pavers come out, and the spoil goes to a transfer station. On narrow canyon streets above Coast Highway, staging is the real constraint: trucks can’t always park at the curb, and we plan the haul route before demo starts. A standard two-car drive is a one-day tear-out. Larger drives or ones with deep failed base run into a second day.
Day 2-3: Grading, base, and compaction
We cut the subgrade to the right slope, usually 1 to 2 percent away from the garage so water never runs toward the door, then lay and compact aggregate in lifts. Each lift gets compacted separately. This is the stage where a homeowner decision matters: whether to add a channel drain at the garage apron, which we recommend on any drive that pitches toward the house.
Day 3-5: Edge restraint and paver setting
Edge restraint goes in first, then the bedding sand, then the pavers themselves. A crew sets roughly 400 to 700 square feet a day on an open rectangular drive. Curves, borders, and herringbone patterns slow that number down. You pick the pattern and any border course before this stage begins, because changing your mind mid-lay costs days.
Day 5-6: Polymeric sand, compaction, and final sweep
We sweep polymeric joint sand into the joints, compact the field, top off the joints, and clean the surface. The drive is drivable once the sand sets, though we tell people to keep heavy vehicles off it for the first few days. Final walkthrough happens at the end, and anything you flag gets handled before we’re done. That workmanship is covered by our 730-Day Done Right Promise.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Actually Choose Between
Most of the decisions on a paver driveway come down to five things. Here’s the honest trade-off on each.
- Concrete pavers vs. clay brick: Concrete pavers are the workhorse, typically 60 to 80 cents lower per square foot installed than clay brick, and they hold color well in salt air. Clay brick runs higher but takes on a patina some homeowners on the ocean side of Coast Highway specifically want.
- Thickness: 60mm pavers suit pedestrian and light vehicle use. 80mm is the standard for a driveway taking a full-size SUV or truck daily. The upcharge is modest and worth it on a slope.
- Pattern: Running bond is the fastest to lay and the least expensive. Herringbone costs more in labor but locks together better under turning tires, which matters on a steep drive.
- Permeable vs. standard: Permeable pavers with open joints and a stone reservoir base cost roughly 10 to 20 percent more, and they’re worth considering where runoff has been a recurring problem or where the lot drains poorly.
- Sealer: A penetrating sealer helps against salt-air staining and joint sand loss. It’s optional, and we’ll tell you honestly whether your drive needs it or not.
We keep a curated set of brand partners across every trade, and Belgard pavers are among the lines we specify most often for their color consistency against Laguna Beach’s stucco and wood exteriors. Finish choices are yours; the quality floor is ours.
What Paver Driveways Cost in Laguna Beach, CA

A paver driveway in Laguna Beach typically lands between $7,000 and $18,000 installed, base prep and haul-off included. Here’s what moves a job toward the low or high end.
| Line item | Typical range |
|---|---|
| Paver driveway installation (full job) | $7,000 – $18,000 |
| Driveway replacement (demo + rebuild) | $5,000 – $14,000 |
| Driveway sealing (after install or later) | $250 – $700 |
Five variables drive the number:
- Square footage: A single-car drive of 300 square feet and a long canyon drive of 800 square feet are very different jobs.
- Existing condition: A failed asphalt surface with good base underneath is cheap to replace. A driveway with a broken subgrade and root intrusion is not.
- Slope and drainage: Steep drives need deeper base, more compaction, and often a channel drain, all of which adds labor.
- Pattern and border: Herringbone with a soldier course adds time and cost over a simple running bond.
- Access: A tight canyon street with no curb parking means a longer haul and more staging time.
A written estimate from us lists the square footage, base depth, paver type, and pattern, plus what’s not included. That’s straightforward, upfront pricing with no surprises. If the job is part of a full Driveway & Pavers in Laguna Beach plan that also takes in a patio or walkway, we’ll break it out line by line so you can see what each piece costs.
See the difference
Before
After
Before
After
Before
AfterWhat Laguna Beach Homes Specifically Do to This Job
Laguna Beach is a built-out canyon-and-cove town, and almost every paver driveway job here sits on a steep, geologically constrained lot that may be in a landslide or high-fire zone. That changes the work. On the canyon streets above Coast Highway, homes are often built on graded hillside pads with pier-and-grade foundations, and driveway drainage has to be planned so winter storm runoff doesn’t pool against the garage or undercut the slope. Marine-layer humidity and salt air off the open coast corrode fasteners and eat away at any edge restraint that wasn’t spec’d for coastal conditions, so we use corrosion-resistant hardware and don’t cut corners on base compaction.
Permitting is its own reality. Laguna Beach runs a small-town permit culture with tight coastal viewshed rules, and anything that changes the driveway footprint or alters drainage may need review before work starts. We pull permits and pass inspections as part of the job; you don’t chase them down. On ridge and canyon properties, wildfire hardening is also on the list, and a non-combustible paver drive is a small but real piece of that. We work across both ZIP codes here, 92651 and 92652, and cover the full Laguna Beach area from the flat streets near the beach to the steep canyon lanes above town. Many of the homes are 1920s to 1970s cottages and midcentury hillside builds, which shapes a lot of our work. Homeowners often pair a new drive with an ADU Design & Permitting in Laguna Beach project, or with a Garage Conversion ADU in Laguna Beach, since access and driveway layout affect both. If you want the wider scope, our Driveway & Pavers service covers it.
Serving Laguna Beach, CA – Our Local Coverage Area
We serve Laguna Beach and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Paver Driveways in Laguna Beach

Most paver driveways in Laguna Beach take three to six working days from demo to final sweep, depending on size, slope, and pattern. A simple rectangular drive runs closer to three; a big hillside drive with curve work and a drain can push past a week. Call (833) 954-6066 for a firm timeline on your specific drive.
Often yes, especially if you’re changing the driveway footprint or how it drains. Laguna Beach’s permit review is thorough, and the answer depends on your lot and slope. We handle the permit application and the inspection as part of the job. Call (833) 954-6066 and we’ll tell you what your project needs.
Expect $7,000 to $18,000 installed, with most jobs landing mid-range. Size, slope, base condition, and pattern are the main cost drivers. Call (833) 954-6066 for a free estimate with a written line-item breakdown.
Sometimes, but on a slope it’s usually a bad idea. Pavers need a compacted base, and laying over failed asphalt means the failure transfers up through the new surface within a couple of seasons. We demo and rebuild the base whenever the existing subgrade can’t hold. Call (833) 954-6066 and we’ll tell you which path your drive needs.
Every paver driveway we install is covered by our 730-Day Done Right Promise. If something isn’t done right, we make it right, and that’s in writing. Call (833) 954-6066 for details on what the promise covers on your project.
Get a Free Paver Driveway Estimate in Laguna Beach
Every estimate for paver driveways in Laguna Beach starts with an on-site walk: we measure the drive, check the slope and drainage, and talk through paver type and pattern. You get a written, line-item number with no surprises, and calls are answered by a live person around the clock. Call (833) 954-6066 to schedule your free estimate and design consult. We also take $1,000 off projects over $10,000, and 0% financing for 18 months is available.
Written by the team at Groundwork Construction Co.












