







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Tub-to-Shower Conversion in Anaheim: What It Costs and How Long It Takes
A tub-to-shower conversion in Anaheim typically runs $3,500 to $10,000 and takes 5 to 10 working days once the permit clears, with most jobs landing in the 7-day range. The work replaces your alcove tub with a code-compliant shower base, waterproofed walls, new valve trim on the existing plumbing, and glass. Call (833) 954-6066 and we’ll walk your Anaheim bathroom and give you a written line-item number.
This page is only about the conversion itself, not the wider remodel. If your project grows into new flooring, vanity, and lighting, that scope lives on our Bathroom Remodeling in Anaheim page.
The Process, Day One Through Punch List

Tub-to-shower conversion is a sequence job, not a weekend swap. Here’s what happens on a standard Anaheim alcove install, stage by stage, and where you make decisions.
Stage 1: Demo and rough inspection (days 1 – 2)
We remove the tub, the surround, and the old valve assembly. A 60-inch alcove comes out in a few hours; cast iron takes longer than fiberglass and often needs a two-person carry down narrow hallways, which many Anaheim ranch homes have. Once the wall cavity is open we check the framing, the subfloor around the drain, and the condition of the existing supply lines. Your decision here: whether the valve gets replaced while the wall is open. It’s the cheapest time to do it, and the last cheap time.
Stage 2: Plumbing and rough-in (days 2 – 3)
The drain gets relocated to the shower position, the pan gets set, and the valve body goes in at shower height. If you’re moving the drain to the center of a wider pan, we cut and re-slope the trap line. Your decision: drain location and whether the shower gets a linear drain, which needs a slightly different framing approach. Most conversions keep the drain within a few inches of the old tub drain to keep the price down.
Stage 3: Waterproofing (days 3 – 4)
This is the part nobody sees and the part that decides whether your shower lasts. We install a bonded waterproofing membrane over cement board, or a pre-sloped foam pan with factory-applied waterproofing, then flood-test the pan before any tile goes on. Rough inspection happens here if your permit requires it. Your decision: nothing on a standard job, but if you want a bench or niche, it has to be framed before this stage closes.
Stage 4: Tile and finish (days 4 – 8)
Wall tile, grout, and caulk at the change of plane, not grout, which cracks. A 12×24 large-format tile runs faster than a mosaic with 40 percent more joints. Glass gets templated after tile is set and installed a few days later, since it’s measured to the finished opening. Your decision: tile layout and whether to add a glass panel versus a curtain rod.
Stage 5: Fixtures, inspection, and walkthrough (days 8 – 10)
Showerhead, valve trim, and door go in last, then the final inspection. We run the water, check the pan slope for ponding, and walk the job with you. That’s where the 730-Day Done Right Promise gets explained in writing, not just mentioned.
Most conversions land on the earlier side of that window when the existing plumbing stays put and the tile is a straightforward porcelain. Add a week if we’re chasing wet rot behind old tile, which comes up more in the citrus-era and 1950s-60s ranch homes in central and western Anaheim than in the hills.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Actually Choose Between
Where your money goes on a tub-to-shower conversion isn’t a secret. It’s base, wall system, tile, valve, and glass. Here’s how those choices read on paper.
- Shower base: A pre-formed acrylic or cultured-marble pan runs $400 – $900 installed and never leaks at the seams because there are no seams. A tiled mud-set or foam pan with a linear drain costs $1,200 – $2,400 but gives you level entry and a custom footprint, useful on tight Anaheim alcoves.
- Wall surround: Acrylic panels are the fastest and cheapest route, $600 – $1,200, and wipe clean in seconds; they look like a hotel shower. Large-format porcelain tile on a waterproofed wall runs $2,500 – $5,000 in materials and labor and holds resale value in an Anaheim market where buyers compare showers.
- Valve and trim: A basic pressure-balance valve runs $250 – $450 installed. A thermostatic valve with a separate volume control costs $600 – $1,100 but lets you set an exact temperature, which matters in homes with shared plumbing runs.
- Glass: A frameless panel with a hinged door runs $1,200 – $2,500 installed. A semi-frameless slider is $700 – $1,400. Mr-Glass enclosures are one line worth pricing if you want a frameless look without the custom lead time.
- Grab bars and bench: If this conversion is partly about aging in place, a framed bench adds $600 – $1,200 and blocking for grab bars is nearly free if planned before tile. Retrofitting after the fact costs three times as much.
None of these numbers include moving a toilet or knocking out a wall. Those are structural changes and belong on a different scope.
What Tub-to-Shower Conversion Costs in Anaheim, CA

The Anaheim market range for this job is $3,500 to $10,000. Here’s the line-item breakdown a written estimate should show you.
| Line item | Typical range |
|---|---|
| Demo, haul-away, and rough prep | $400 – $900 |
| Plumbing rough-in and valve | $600 – $1,400 |
| Pan and waterproofing | $700 – $2,000 |
| Wall tile or surround | $1,200 – $4,000 |
| Glass door or panel | $700 – $2,500 |
| Fixtures and trim | $250 – $600 |
| Permit | $200 – $500 |
What pushes a job toward the top of the range: relocating the drain more than a few inches, moving a toilet or knocking out a wall to widen the shower, wet rot behind old tile, upgrading to frameless glass with premium stone-look porcelain, and heavier permitting when plumbing lines get reconfigured. A straightforward conversion with the valve in the same spot and standard porcelain tile lands near $5,000 – $7,000.
What’s included: permit, demo, waterproofing, tile or surround, valve and fixtures, glass, cleanup, and the 730-Day Done Right Promise. What’s typically not: drywall repair outside the shower alcove, floor tile beyond the shower footprint, and painting. Those get quoted separately so there’s no “while we were in there” surprise.
Upfront pricing means the number you see is the number you pay. We also take $1,000 off projects over $10,000 and offer 0% financing for 18 months if you’d rather spread the cost.
See the difference
Before
After
Before
After
Before
AfterWhat Anaheim Homes Specifically Do to This Job
Anaheim’s housing stock splits this job in two. The 1950s-60s ranch tract homes and citrus-era bungalows in the central and western ZIPs (92806 and the older core) mostly have 5-foot alcove tubs with cast iron or early fiberglass pans and galvanized or early copper supply lines. On a conversion there, the real cost driver is what’s behind the tile: we’ve pulled surrounds off and found ninety-year-old framing with a wet sill plate where a slow valve leak had been soaking for years. The fix is a new sill and stud replacement, and it needs to happen before waterproofing, not after.
In the Anaheim Hills ZIPs (92807), custom and hillside homes often have larger master baths with 72-inch garden tubs, which convert into generous walk-in showers with room for a bench and a bench is usually what people ask for. Slope lots mean the drain line has more fall to work with, so a linear drain is easier there than on a flat tract slab.
Permitting is straightforward but not optional. Anaheim requires a permit for shower conversions that touch plumbing, and inspection covers rough plumbing and final. We pull it. Dry Santa Ana wind seasons and clay-heavy soils don’t affect a shower directly, but they do mean foundation movement in hillside lots, and that movement is where we see grout cracks at the wall-to-floor joint that a flexible sealant handles better than grout would.
If your project grows into roof or exterior work while we’re there, homeowners often pair this with Metal Roofing in Anaheim or Tile Roofing in Anaheim to keep one crew on the property. We cover the full city as part of our Anaheim service area, and this sits inside our broader Bathroom Remodeling work.
Serving Anaheim, CA – Our Local Coverage Area
We serve Anaheim and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Tub-to-Shower Conversion in Anaheim

Most conversions take 5 to 10 working days from demo to final inspection. Simple jobs with standard porcelain tile and the drain staying in place finish near 5 to 7 days; jobs with wet rot repair, custom glass, or a relocated drain run to 10 or a bit more. Call (833) 954-6066 for a schedule based on your actual bathroom.
Yes, if the project touches plumbing, which most conversions do because the drain and valve are being reconfigured. Anaheim inspections cover the rough plumbing and the final finish. We pull the permit and manage the inspection; it typically adds $200 – $500 to the job and a few days to the calendar.
Yes, and keeping the drain within a few inches of the old tub drain is the cheapest path. The valve body usually stays in the same wall cavity. Moving the drain to the center of a wider pan or shifting it for a bench adds framing and re-slope time, which pushes the job $800 – $1,800 higher.
Anaheim jobs run $3,500 to $10,000, with $5,000 – $7,000 the most common landing point for a straightforward porcelain-and-glass conversion. Frameless glass, stone-look tile, and a relocated drain push you toward the top. Call (833) 954-6066 for an exact quote after we see your bathroom.
Every conversion is covered by the 730-Day Done Right Promise. If something isn’t right, we come back and make it right, within two full years of completion. Our technicians have up to 12 years of experience, arrive in uniform, and are background-checked.
Get a Free Tub-to-Shower Conversion Estimate in Anaheim
Call (833) 954-6066 for a free on-site estimate. A live person answers, every hour of every day. We measure the alcove, check the plumbing and subfloor, and hand you a written line-item quote with the permit and glass priced in, not added later. No change orders unless the wall cavity hides something we’ll show you before we touch it. Anaheim homeowners get a straight number and a firm promise.
Written by the team at Groundwork Construction Co.












