







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Aluminum Fence in Tustin: What It Costs and How Long It Takes
Aluminum fence installation in Tustin typically runs $4,000 – $10,000 for a standard residential lot, and most jobs wrap in three to five working days once materials land. You’re buying a powder-coated, rust-proof barrier that shrugs off Tustin’s hot dry summers and Santa Ana wind events without the rot, warping, or repainting a wood fence demands. Call (833) 954-6066 for a free on-site estimate. We measure the actual run and give you a written line-item number, not a ballpark.
How We Install an Aluminum Fence, Start to Finish

Aluminum fencing isn’t a weekend project you muscle through with a rented auger. The panels are pre-manufactured, but everything holding them up has to be set with precision or the whole run looks crooked six months later. Here’s the real sequence.
Stage 1: Walkthrough and measurement (about 60 – 90 minutes)
We walk the property line with you, confirming exactly where the fence goes and where it doesn’t. This is where you decide the run length, gate locations, and whether you’re butting up against a neighbor’s existing fence or starting clean. We also check for irrigation lines, low-voltage lighting, and utility easements. That last part matters on Tustin Legacy lots where newer infrastructure runs close to the surface.
Stage 2: Layout, marking, and utility check (day one)
We mark every post hole with paint or stakes and call in the 811 utility locator before anyone touches a shovel. Aluminum needs a post roughly every 6 to 8 feet, so a 150-foot run means 20 to 25 holes. Each location gets confirmed against the locator flags. On a typical Tustin lot this takes half a day. You don’t need to be home for it, but we’ll send photos once the layout is marked.
Stage 3: Excavation and post setting (day one into day two)
Posts go into concrete footings set below the frost line, which in Tustin means a straightforward 24 to 30 inches depending on post height and wind exposure. We dig, set, plumb, and brace each post, then let the concrete cure. Cure time is the biggest schedule variable here. Fast-set mixes let us hang panels the next morning; standard concrete wants a full day. If you’re on a slope, we step the fence to follow grade rather than leave gaps at the bottom, and that stepping adds a little time.
Stage 4: Panel and gate installation (day two into day three)
Rails and pickets go up once the footings are solid. Panels are racked to match grade, gates get hung on heavy-duty hinges with a positive latch, and we check every post for plumb and every panel for level as we go. Gate hardware is where cheap installs fail first, so we set the latch strike and check the swing before we call it done. Expect this stage to run one to two days depending on how many gates you’ve added.
Stage 5: Final walkthrough and cleanup (day three to five)
We haul off spoils, sweep the line, and walk the finished fence with you. Any post that’s out of plumb gets corrected before we leave. You get the written warranty paperwork at the same time. Most Tustin jobs land inside five working days from the first dig, and often the run is up in three once footings cure fast.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Aluminum Fence Options You’ll Choose Between
Aluminum isn’t one product. The choices below are what actually change how the fence looks, how it holds up, and what you pay.
- Powder-coat finish and color: Standard black, bronze, and white are the most available and the cheapest. Custom colors and wood-grain finishes cost more. Powder coat is what keeps aluminum from oxidizing, so a quality coat matters more than a fancy color. Cheap finishes chalk and fade within a few years under Tustin’s sun.
- Pickup and rail style: Three-rail, two-rail, and flat-top or spear-top picket profiles are the common choices. Ornamental spear-top runs a bit higher than a plain flat-top. If you want the look of wrought iron without the rust, this is where aluminum earns its keep.
- Residential vs. commercial grade: Residential aluminum uses lighter posts and rails; commercial grade is heavier and costs more but holds up better on long runs, steep grades, or high-wind exposure. On an exposed Tustin ridge lot, the heavier grade is worth it.
- Gate configuration: Walk gates are standard. Drive gates, self-closing gates, and arched gates add cost and hardware complexity. Decide gate width now, because retrofitting a wider gate later means resetting posts.
- Height: Four-foot and five-foot runs are typical for residential. Six-foot runs cost more in material and posts, and some HOAs cap height, so check before we order.
What Aluminum Fence Costs in Tustin, CA

Most aluminum fence jobs in Tustin land between $4,000 and $10,000 installed. Here’s what moves a job toward the low or high end of that range.
- Linear feet: The single biggest driver. A short 60-foot side-yard run sits near the bottom; a full perimeter around a quarter-acre lot pushes toward the top.
- Grade and terrain: Flat runs are fast. Stepped or sloped runs need extra posts and racking, which adds labor.
- Gate count and type: Each gate adds hardware, framing, and install time. Drive gates cost meaningfully more than walk gates.
- Material grade and finish: Heavier commercial-grade aluminum or a custom color adds to the material line.
- Site conditions: Rocky soil, root-bound lines, or tight access for equipment all add labor. Old Town lots with mature trees often need hand-digging around roots.
Your written estimate lists the linear footage, post count, gate count, finish, material grade, footing depth, demo of any old fence, and haul-away. What it typically doesn’t cover: utility relocation if a line sits directly in the fence path, landscape repair beyond the fence line, or HOA submission fees. We pull any required permits and handle the inspection, and the number you sign is the number you pay. If this is part of a bigger yard project, see our Fence Installation in Tustin page for the full scope.
See the difference
Before
After
Before
After
Before
AfterWhat Tustin Homes Specifically Do to This Job
Tustin splits into two very different fence realities, and they change the job. In Old Town, we’re working century-old Craftsman and Spanish Revival bungalows where property lines are tight, mature trees crowd the fence path, and older irrigation or root systems slow the dig. Those lots often need a hand-dug approach rather than machine work. Out in Tustin Legacy, on the former Marine Corps Air Station Tustin footprint, we’re fencing new master-planned homes built on former airfield land. Post depths and footing prep there are straightforward, but utility flags matter more because newer infrastructure runs close to the surface and HOA design review for fence color and height is common. The semi-arid climate drives the material choice too: hot, dry summers and Santa Ana wind events beat on anything that can’t take sun exposure, and aluminum handles that far better than wood. Between a heritage Old Town lot and a Legacy build, the same fence height can mean a different installation day.
Serving Tustin, CA – Our Local Coverage Area
We serve Tustin and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Aluminum Fence in Tustin

Most aluminum fence jobs in Tustin take three to five working days from first dig to final walkthrough. A simple flat side-yard run can finish in three; a full perimeter with multiple gates and stepped grade runs closer to five. Call (833) 954-6066 for an exact timeline on your lot.
Many Tustin fence projects require a permit, and height limits and setbacks vary by zone, so we check the requirement for your specific address before we order material. Some HOAs add their own design review on top. We pull what’s required and handle the inspection, so the fence isn’t the thing that trips up a future sale. Call us and we’ll confirm what applies to your property.
Usually yes. Aluminum posts are set on a spacing that often lets us work around existing shrubs, irrigation, and low-voltage lines. Where a utility line sits directly in the path, we’ll flag it during layout and adjust the post position before digging. Call (833) 954-6066 and we’ll walk the line with you at the free estimate.
Aluminum fence installation in Tustin runs $4,000 – $10,000 for a standard residential job, with linear footage, grade, gate count, and material finish driving the final number. You get a written line-item estimate with the exact figures. Call (833) 954-6066 for a free on-site quote.
Every aluminum fence project is covered by our 730-Day Done Right Promise: if it’s not done right, we make it right. That covers workmanship on posts, panels, and gate hardware for two full years. Call (833) 954-6066 and we’ll go over exactly what’s covered.
Get a Free Aluminum Fence Estimate in Tustin
We’ll come out, measure your actual run, confirm utility and HOA considerations, and hand you a written line-item estimate for your aluminum fence in Tustin. No pressure, no surprise add-ons. Homeowners across Tustin often pair a new fence with Driveway Repair & Replacement in Tustin or new hardscape, and we can quote both in one visit. See our Fence Installation service for the broader scope. Many homeowners also pair this with Patios, Walkways & Pool Decks in Tustin to finish the yard in one stretch. Call (833) 954-6066 to schedule your free estimate.
Written by the team at Groundwork Construction Co.












