







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Concrete Driveways & Concrete Work in Yorba Linda, CA
Concrete Driveways & Concrete Work in Yorba Linda typically runs $4,500 – $12,000 for a new concrete driveway, with most hillside-lot pours landing between $6,500 and $10,500 once grading and slope drainage enter the picture. A standard flat-lot driveway takes 3 – 5 working days from demo to first drive-on; a steep ridgeline approach with retaining and drainage work stretches to 2 – 3 weeks. Call (833) 954-6066 and we’ll walk your lot and put a written number in front of you.
How a concrete driveway actually gets built, start to finish

Concrete work looks simple from the street. It isn’t. Here’s the real sequence we run on a Yorba Linda job, and where you make a decision at each step.
Stage 1: Site walk and layout (day 1)
We measure the existing approach, check the slope from the street to the garage, and note where water currently runs. On hilly lots off the eastern ridgelines this is the stage where we find out whether a retaining wall or a drainage swale needs to be part of the job at all. You decide the driveway width and whether the apron gets widened for a second vehicle. Expect 60 – 90 minutes.
Stage 2: Demolition and haul-off (days 1 – 2)
Old concrete, asphalt, or decomposed granite comes out with a breaker and a skid steer. A typical two-car driveway produces 15 – 25 tons of debris that has to leave the site. You decide whether the existing base stays (cheaper) or gets pulled to bare subgrade (correct if the old slab cracked from clay movement). On Yorba Linda’s clay, we usually push for full removal.
Stage 3: Grading, base, and formwork (days 2 – 4)
We cut to final grade, compact 4 – 6 inches of class II base in lifts, and set forms to a minimum 1.5% slope away from the garage. If a retaining wall is in scope, it goes in before the pour, not after. You confirm the final layout here, in person, before anything is fixed in place. This is also your last easy chance to add a widened apron or a built-in drainage channel.
Stage 4: Rebar, inspection, and pour (days 4 – 5)
We set #3 or #4 rebar on a grid, tie it, and place chairs so the steel sits mid-slab rather than on the dirt. Where the city requires it, we hold for inspection before the pour. Then the concrete goes down, gets screeded, floated, and finished to your chosen texture. You pick finish and control-joint layout before this stage starts, not during.
Stage 5: Cure and sealing (days 5 – 30)
You can walk on it in 24 – 48 hours and park on it around day 7, but full cure takes about 28 days. We come back for a cure-and-seal coat once the slab has dried enough, which is what protects it through the first hot inland summer. You decide whether to seal now or wait a season.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The options you’ll choose between
Most of the cost difference between a $4,500 driveway and a $12,000 one lives in these choices, not in labor rates.
- Standard broom finish: the workhorse. Good grip, hides tire marks, and it’s the cheapest finish. Suits a family that just wants a clean, honest slab.
- Exposed aggregate: the top layer is retarded and washed to reveal the stone. Adds roughly 15 – 25% to the pour cost, holds up well to sun, and gives a warmer look than plain gray. Popular on Yorba Linda homes where the driveway is visible from the street.
- Slab thickness: 4 inches is the residential minimum. We push 5 – 6 inches for anything that sees a truck, an RV, or heavy delivery traffic, and that added thickness is part of why a bigger job climbs toward the top of the range.
- Rebar vs. mesh: welded wire mesh is cheaper and fine on a firm, protected slab. Rebar on a proper grid is the right call on clay soil that moves, which is most of this city. The price gap is real but small next to replacing a cracked slab.
- Control joints and layout: joints every 8 – 12 feet in a pattern that actually looks deliberate. Skip them and you’ll get random cracking instead.
- Drainage: a channel drain or a slope-tuned swale keeps water off the garage door and out of the foundation line. On hillside lots, this is not optional.
- Mix supplier: we use ready-mix from established plants for driveways. Bagged product like Sakrete has its place for small aprons and repairs, but not a full pour where you want consistent strength.
What Concrete Driveways & Concrete Work costs in Yorba Linda, CA

Plan on $4,500 – $12,000 for a new concrete driveway, and $5,000 – $14,000 if the old surface has to come out and be replaced. A driveway sealing coat, when the slab is sound, runs $250 – $700. Here’s what pushes a job toward the low or high end.
- Square footage and thickness: a 400 sq ft single-car apron sits near $4,500. A 700 sq ft two-car driveway at 5 – 6 inches climbs toward $12,000.
- Existing condition: demo, haul-off, and full base removal on a failed slab add cost. If the old concrete has to be broken out and trucked away, that’s real tonnage and real dollars.
- Slope and grading: hillside lots need cut-and-fill, sometimes a retaining wall, sometimes a drainage swale. This is the single biggest driver here versus a flat lot in a neighboring city.
- Material grade: exposed aggregate and thicker slabs with rebar sit at the top. Plain broom finish on mesh sits at the bottom.
- Permit scope: a straight replacement usually needs no building permit; a new approach, a wall, or significant grading can trigger city review, which adds time and a fee.
Our written estimate is line-item: demo, base, rebar, thickness, finish, drainage, disposal, and permit fees if any. No change orders surprises. The number you see is the number you pay, and it’s backed by the 730-Day Done Right Promise.
See the difference
Before
After
Before
After
Before
AfterWhat Yorba Linda homes specifically do to this job
Yorba Linda was built on former ranch and citrus land, and a large share of its housing arrived as 1960s – 1980s custom and semi-custom homes on generous hillside lots across 92886 and 92887. That shape changes concrete work in ways a flat tract city never sees. On the steep ridgeline lots off the eastern hills, a driveway pour is really a grading job with a slab on top: we routinely build retaining walls and tune drainage to satisfy the City of Yorba Linda’s own hillside and slope-stability review, and that review runs through the city’s building department rather than the county. Then there’s the soil. Yorba Linda’s clay swells with winter rain and shrinks through the hot, dry Santa Ana wind season, and that wet-dry cycle is the most common reason driveways here crack in the first place. We plan for it with full base removal, rebar on a grid, and control joints laid out on purpose. Homes near the Nixon birthplace and along the older ranch-era streets often have narrower original approaches, so widening one is a common ask. Permitting for a straight replacement is usually light; new grading, a wall, or a driveway that changes the approach is where the city review kicks in.
Serving Yorba Linda, CA – Our Local Coverage Area
We serve Yorba Linda and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked: Concrete Driveways & Concrete Work in Yorba Linda

A typical job takes 3 – 5 working days from demo to the finished slab, plus about 7 days before you park on it and 28 days for full cure. Hillside lots with grading or a retaining wall stretch to 2 – 3 weeks. Call (833) 954-6066 for a timeline specific to your lot.
A straight driveway replacement usually doesn’t require a building permit, but new grading, retaining walls, or a changed street approach often do. We handle the permit application and inspection scheduling when it’s needed, so you’re not chasing the city yourself. Call (833) 954-6066 and we’ll tell you which bucket your project falls into.
Sometimes, but not often on Yorba Linda clay. If the existing slab is sound and the base is intact, an overlay can work; if it has cracked from soil movement, an overlay just cracks again. We’d rather tell you the truth up front than pour over a problem. Call (833) 954-6066 for an honest assessment.
Most concrete driveway installation here runs $4,500 – $12,000, and a full replacement runs $5,000 – $14,000. Slope, grading, drainage, and material grade move the number most. Call (833) 954-6066 for a free on-site estimate with a line-item number.
Every concrete project is covered by our 730-Day Done Right Promise: if it isn’t done right, we make it right. That’s one of the longest workmanship guarantees in residential construction, and it’s in writing before we start. Call (833) 954-6066 to go over the details.
Ready to price your concrete project?
We’ll come out to your Yorba Linda property, walk the lot, check the slope and existing base, and hand you a written line-item estimate for your Concrete Driveways & Concrete Work. No pressure, no vague bids. Call (833) 954-6066 for a free on-site estimate; a live person answers around the clock. If the driveway is part of a bigger plan, our Driveway & Pavers service covers the wider scope, and we also handle a Garage Conversion ADU in Yorba Linda or a New Detached ADU in Yorba Linda that homeowners often pair with a new approach. For the full vertical, see Driveway & Pavers in Yorba Linda, and for the rest of our work across Yorba Linda, we’re happy to talk it through.
Written by the team at Groundwork Construction Co.












