







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Vanities, Tile & Fixtures in Yorba Linda, CA: What the Job Actually Involves
Replacing a vanity, retiling a bathroom floor or shower surround, and swapping fixtures in Yorba Linda typically runs $9,000 – $28,000 for a full bathroom’s worth of surface and fixture work, and the job usually takes two to three weeks of working days. The number swings hard depending on whether plumbing moves, what tile you pick, and how much of the original 1970s or 1980s substrate has to come out. Call (833) 954-6066 for a free on-site estimate and a written line-item quote before anything gets demoed.
How We Sequence Vanities, Tile & Fixtures Work

This isn’t a gut remodel. It’s a surgical replacement of the surfaces and fixtures a Yorba Linda bathroom shows every day, and the order matters more than most homeowners expect. Here’s how the two-to-three weeks actually break down.
Stage 1: Demo and tear-out (days 1 – 2). We pull the old vanity, disconnect and cap the supply lines, remove the toilet and existing tile, and strip the floor and shower walls down to substrate. A homeowner decision lands here: if the drywall or cement board behind the tile is water-damaged, you’ll see it in photos before we quote the repair. This is also the moment we confirm whether the shutoff valves are original, because 1980s-era valves often seize and get replaced now rather than mid-project.
Stage 2: Rough-in and substrate (days 3 – 5). If the vanity is moving, or the new fixture layout differs, the plumber and electrician rough in here. Then cement board goes up on wet areas with a waterproofing membrane. This is the stage that eats the budget if surprises show up, and it’s exactly why we open walls before quoting rather than after.
Stage 3: Tile setting (days 6 – 10). Floor tile first, then walls. Large-format porcelain goes down faster than a small mosaic but demands a flatter substrate, so we check floor flatness before the first bag of thinset. Grout and sealant cure overnight, and you’ll want to decide on grout color and layout before we start setting, not during.
Stage 4: Vanity and top install (days 11 – 13). Cabinet set, countertop templated and installed, sinks dropped in or undermounted, faucet and drain connected. If you’re using a stone or quartz top, the template happens after cabinets are level, which is why this stage can’t be rushed.
Stage 5: Fixtures, trim, and punch list (days 14 – 15). Toilet reset, mirror and lighting hung, towel bars and trim installed, then a full water test and cleanup. You walk the room with us before we call it done.
Every job carries our 730-Day Done Right Promise, and the technicians doing the tile and fixture work have up to 12 years of experience. If something isn’t right, we come back and make it right.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Actually Choose Between
- Vanity cabinet stock vs. custom: A ready-made 48-inch cabinet runs a fraction of a custom build and installs in a day; a custom vanity fitted to an odd wall or a tight door swing costs more and adds a week of lead time. KraftMaid cabinetry sits in the middle and gives you real finish choices without full custom pricing.
- Countertop material: Quartz holds up to water and daily wipe-downs and doesn’t need sealing; natural stone looks richer but needs resealing every year or so. Cambria quartz is a common pick for its consistent pattern and stain resistance.
- Floor tile: Porcelain is the workhorse – dense, water-resistant, and forgiving on a busy bathroom floor. Natural stone (travertine, slate) is beautiful but softer and needs more care. Large-format tile means fewer grout lines; smaller tile grips better underfoot in a shower.
- Fixtures finish: Chrome is the value pick; brushed nickel and matte black cost a bit more and hide water spots differently. Kohler fixtures are a frequent choice for the faucet and shower trim.
- Shower wall tile vs. larger slab: Tile is repairable piece by piece; a slab is seamless but pricier and harder to fix if it chips.
Fixtures aren’t just vanity checks – if the bathroom shares a wall with exterior windows, homeowners often pair this with ES Windows or Therma-Tru replacements while the wall is open. And the wider bathroom scope, from the shower build to layout, lives on our Bathroom Remodeling in Yorba Linda page, while the full-service picture is under Bathroom Remodeling.
What Vanities, Tile & Fixtures Costs in Yorba Linda, CA

Most jobs land between $9,000 and $28,000. Here’s the line-item range a free estimate will build from, so you can see where your money goes:
| Line item | Typical range |
|---|---|
| Bathroom vanity installation | $800 – $3,000 |
| Shower replacement (surround + fixtures) | $3,000 – $8,500 |
| Full bathroom surface and fixture refresh | $9,000 – $28,000 |
Five things push a job from the low end to the high end:
- Relocating plumbing or electrical: moving a drain or adding a GFCI outlet for a lighted mirror adds real time and cost.
- Substrate condition: water-damaged cement board or rotted framing under old tile gets discovered on demo day and gets fixed, not covered.
- Tile grade and size: large-format porcelain and natural stone cost more in material and in set time.
- Vanity size and custom vs. stock: a custom cabinet fitted to a narrow alcove runs higher and takes longer to arrive.
- Permit scope: fixture and finish swaps often need less paperwork than moving walls or plumbing, so what’s permitted changes the timeline.
Your written quote itemizes materials, labor, permit cost, and allowance for anything that can’t be seen until demo. Prices stay fixed – the number you see is the number you pay, backed by upfront pricing with no surprises, 0% financing for 18 months, and $1,000 off projects over $10,000.
See the difference
Before
After
Before
After
Before
AfterWhat Yorba Linda Homes Specifically Do to This Job
Most of the bathrooms we retile in Yorba Linda sit inside 1960s-to-1980s houses on the large lots across 92886 and 92887, and that build era shows up the moment you pull the old vanity. Original shutoff valves, galvanized supply lines, and cement board that’s seen thirty-plus years of moisture are the common culprits. Yorba Linda’s hot, dry inland summers and Santa Ana winds dry tile and grout joints hard, and clay soil that swells with winter rain cracks the slab these bathrooms sit on – a hairline crack in the floor is a real thing to check before installing new tile over it. Permitting runs through the City of Yorba Linda’s own building department, and hillside homes off the eastern ridgelines sometimes carry grading or structural scope that a flat lot in Anaheim doesn’t. Because so many lots are custom and semi-custom, we measure every wall and door swing instead of assuming a standard vanity fits. If your exterior is getting checked while we’re at it, homeowners often pair this with Tile Roofing in Yorba Linda or, on a steeper lot, Specialty Roofing in Yorba Linda.
Serving Yorba Linda, CA – Our Local Coverage Area
We serve Yorba Linda and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Vanities, Tile & Fixtures in Yorba Linda

Most jobs take two to three weeks of working days. The tile setting and cure time is the slowest stretch; a vanity-only swap with no tile work can finish in a few days. Call (833) 954-6066 for a schedule tied to your actual scope.
Often not, but it depends on scope. Swapping a vanity, retiling, or replacing fixtures typically needs no permit, while moving plumbing, relocating a toilet, or adding electrical does. We tell you at the estimate which applies and pull what’s required through the City of Yorba Linda.
Yes, and that’s the most common path. Retiling, a new vanity in the same spot, and fresh fixtures leave the plumbing where it is. Moving a drain or shifting the vanity is possible but adds cost and time, so we price both.
Expect roughly $9,000 – $28,000 for full surface and fixture work. The variables are plumbing relocation, tile grade, and what demo uncovers. Call (833) 954-6066 for an exact quote – estimates are free.
Every project is covered by our 730-Day Done Right Promise, so if anything isn’t right, we make it right. Materials also carry their manufacturer warranties, and we hand over the documentation at final walkthrough.
Get a Free Estimate on Vanities, Tile & Fixtures in Yorba Linda
Book a free on-site estimate for vanities, tile & fixtures in Yorba Linda. Call (833) 954-6066 and a live person answers around the clock. We’ll walk the bathroom, measure for the vanity, talk through tile options, and hand you a written line-item quote with fixed pricing. You’ll know what the job costs before anything comes out of the wall – and our team covers the 92886, 92887, and 92885 ZIPs across Yorba Linda.
Written by the team at Groundwork Construction Co.












